|
Search:
Advanced search
|
Browse by category:
|
Glossary | Contact Us |
SEH set up |
|||||
SEH printserver InterCon Setup
1. Click – My Computer
2. Right click on the CD icon
3. Select “Explore” from menu
4. Double click on the “NetTool” folder
5. Double click on “Windows” folder
6. Double click “NetTool” Setup
7. Follow prompts to complete installation
· Connect the SEH box ONLY to the network cable, NOT to the printer. Use a crossover cable if you are connecting directly to a computer. Use a standard cable if you are connecting using a ‘router’ or ‘hub’.
· After completing 1 – 7 above, launch InterCon from the desktop icon or find InterConTools in your Programs folder.
· Double click on the IP address (most likely all zeros). (Loading properties menu should open).
· Select TCP/IP tab on the left.
· Remove the ‘checks’ in the boxes from all items except ARP/Ping. Specifically DHCP.
· ‘Check’ the TCP/IP box and Enter your IP address and submask then click OK. A Gateway is not required.
· Verify the IP address line changes to your entered address. The printer icon should show a red X through it.
· Connect the SEH box to the printer LPT port. The red X should come off when the printer is powered ON. Click the Refresh or Rebuild buttons to make it change if it doesn’t automatically refresh itself. Notice that the SEH utility now shows the name of the printer.
Print server is now configured for your network and IP address.
· Setup up your RIP
software for the IP address of the SEH box.
|
|||||
Powered by
KBPublisher (Knowledge base software)