|
Search:
Advanced search
|
Browse by category:
|
Glossary | Contact Us |
Connecting an Ultima Cutter to a PC |
|||||
CONNECTING THE CUTTER TO THE COMPUTER To make the connection between the cutter and the computer, you are offered two possibilities. The first possibility is a 2-way RS-232C serial interface. The second possibility is a USB interface. SERIAL INTERFACE The serial RS-232C interface enables the cutter to be connected to and controlled by an RS-232C compatible host computer system. The cutter is equipped with a standard RS-232C - DB-9P connector on the rear panel and requires a standard RS-232C DB-9S mating connector. Step 1 : interface cable Make sure both the cutter and the computer are turned off. Connect one end of the serialto the serial interface connector at the rear side of the cutting plotter.Step 2 : Fasten the screws to secure the connector.Step 3 : Notes : For proper operation of the serial communication, it will be necessary to match the computer settings to the plotter settings ! Connect the other end of the serial cable to your computer.USB INTERFACE Step 1 : Make sure the USB driver is installed.Step 2 : Connect one end of the USB cable to the USB connector at the rear side of the cutting plotter.Step 3 : Notes : Using the serial/USB communication, your cutter will not only be able to receive data from the computer, but will also be able to send information to the computer (media size, ...). Connect the other end of the USB cable to your computer or the network. |
|||||
