This section describes how to move or transport the printer.

6.4.1 Moving the printer

This sub-section describes how to move the printer.

•	Move the printer maintaining a horizontal position.
•	Do not slant the printer, prop it against a wall or turn it upside down. There is a possibility that ink inside the printer may leak. Moreover, normal operation after shifting (to these positions) cannot be guaranteed.

(1) Preparation before moving

When using the dedicated stands, follow the procedure below to move the printer.

1	Make sure that the printer is turned OFF. $graphics\nzilg007.gif$ 3.2.2 Turning the power OFF

2	Dispose of waste fluid. $graphics\nzilg007.gif$ 6.3 Disposal of waste fluids

3	Remove the media-feed table. $graphics\nzilg007.gif$ 3.4.2 Removing the Media-feed Table

4	Remove all the cables, such as the power cable.

5	Loosen the four adjusters of the stand as shown in the next illustration.

Move the printer.

•	The casters supplied with the dedicated stand are manufactured for little movement in flat indoor areas, not for transporting equipment.

$graphics\VJ1608A619A.gif$

No.

Name

Adjusters

Stands

(2) Reinstalling

After moving the printer, follow the procedure below to set it ready for use.

1	Select a suitable place for installation. $graphics\nzilg007.gif$ Installation manual

2	Move and install the printer to the location.

3	Attach cables, such as the power cable. $graphics\nzilg007.gif$ 3.1 Power cable connection $graphics\nzilg007.gif$ 3.7 Connecting the printer to PC

4	Perform Nozzle check, and then confirm that there is no clogging in the print head. $graphics\nzilg007.gif$ 3.5.1 Nozzle check

5	Perform Alignment. $graphics\nzilg007.gif$ 3.6 Adjust print

6.4.2 Transporting the printer

When transporting the printer, it is necessary to pack in the same condition as purchased using protective and packing materials to protect the printer from vibration and shocks.

•	When transporting the printer, consult the MUTOH product dealer at your point of purchase.