|
|
Jagged Looking Cuts
Sometimes vinyl or other foreign material become lodged in the knife holder
cavity preventing the cutting blade from swiveling freely, resulting in a jagged
looking cut. To fix this problem, remove the knife holder cap and clean out
any foreign matter that has gathered there. This should be done on a daily
basis or when cut quality is suddenly impaired. If you have an SC (or an XPC
with the sheet-off option) be sure to inspect the sheet-off knife for this
condition as well.
Note: The knifeholder as well as the knife blade are consumables so
after some time it may be recessary to replace both items. If foreign
material is allowed to accumulate at the tip of the knifeholder it won't be
long before debris gets into the bearing and knifeholder replacement will be
necessary. A dull blade my be OK for using with large characters but
will not give the fine cutting accuracy required for detail cuts.
|
