|
|
SignLab Setup
After you have followed all instructions from your SignLab sales representative
try these suggestions.
If you are a SignLab user your serial port and Cutter communications should
be set to Mutoh "default 4". Which is; 9600 baud, 8 databits,
no parity, 1 stopbit, handshake is Xon-Xoff, DTR is ON, CTS is OFF, RTS is
ON. The Cutter should also be set to "page mode 1".
For XPC model, press 'remote' and scroll the menu looking for Communication.
Select Default 4.
For SC model, Print the 'setup' sheet to change to or confirm that the communication
parameters are set to, Default 4.
|
